1. Operation Log
This page shows operation logs.
Click 
to check log details.
General operation log details are shown as follows:
2. Config Log
2.1 Action View
The configuration logs record the information about configuration changes and pushing in three levels. In the figure, the first level records operation types that cause the configuration change or configuration pushing. The operation types include: apply templates, update templates, switch templates, and version upgrade. In addition, the first-level logs also record the running status statistics and some parameters.
1. Click 
to check APs involved by the operation type.
2. Click the rightmost action column (
) of the second-level logs to check the push status of each configuration item.
The following figure shows an example of full configurations, including the configuration execution status of SSID, Radio and so on.
2.2 Device View
Click the rightmost action column (
) of the second-level logs to check the push status of each configuration item.
The following figure shows an example of full configurations, including the configuration execution status of SSID, Radio and so on.
3. Upgrade Log
This part provides the upgrade tracing function, and enables checking upgrade status, aborting the upgrade, and retry.
Click 
to check log details.
Click 
to top the upgrade task if the upgrade command has not been pushed.
Click 
to restart the upgrade task that failed or was aborted.
Click 
to restart sthe upgrade task.
Click 
to stops the upgrade task.
Abort: You cannot stop the upgrade task if the upgrade command has been pushed to the AP.
Retry: You can only restart the failed or aborted upgrade task.